2022 Latest 100% Exam Passing Ratio - NS0-184 Dumps PDF
Pass Exam With Full Sureness - NS0-184 Dumps with 60 Questions
NetApp NS0-184 Exam Topics:
| Section | Objectives |
|---|---|
| ONTAP Concepts | - Identify how to update ONTAP - Identify ONTAP cluster controller components - Describe how to create aggregates - Describe the required steps for installation or expansion of an ONTAP cluster |
| ONTAP Networking | - Describe how to configure ONTAP system networking - Describe network types used with ONTAP clusters |
| ONTAP Configuration | - Describe how to add or remove nodes in an ONTAP cluster - Describe how to set up cluster peering - Describe how to implement security hardening - Describe support resources required for troubleshooting ONTAP installations |
| Customer Handoff | - Describe the tools available to review an installation - Describe the process for handover of new ONTAP cluster installation to the customer - Identify how to create documentation |
| ONTAP Switches | - Describe cabling of a switched cluster - Identify the software needed for cluster switch configuration |
NetApp NS0-184 Exam Certification Details:
| Sample Questions | NetApp NS0-184 Sample Questions |
| Passing Score | 67% |
| Exam Price | $150 USD |
| Exam Registration | PEARSON VUE |
| Recommended Training | ONTAP Cluster Administration (vILT/ILT) Universal FAS Installation (WBT) ONTAP Hardware Component Troubleshooting and Analysis |
| Exam Code | NS0-184 NCSIE |
| Exam Name | Storage Installation Engineer ONTAP |
NEW QUESTION 14
What are two ways to identify an AFF All SAN Array system? (Choose two.)
- A. Use the cluster image show CLI command.
- B. View the ONTAP System Manager system nodes.
- C. Use the san config show CLI command.
- D. View the ONTAP System Manager cluster settings.
Answer: B,C
NEW QUESTION 15
One of the nodes in your ONTAP 9.7 cluster has failed and is not coming back online.
Which two methods would you use to connect to the node failing to come back online? (Choose two.)
- A. Use the Intelligent Platform Management Interface.
- B. Use Secure Shell.
- C. Use the Service Processor Interface.
- D. Use Telnet.
Answer: B,C
NEW QUESTION 16
Click the Exhibit button.
You are reviewing the setup of a recently installed FAS9000 switched cluster. As shown in the exhibit, the cluster interconnects are connected to a pair of Cisco Nexus 3132Q-V 40 Gb ports.
For a high availability, which ports should swap Ethernet cables?
- A. Swap node2:e4a and node2:e8a.
- B. Swap node1:e8a and node2:e4a.
- C. Swap node1:e4a and node2:e4b.
- D. Swap node1:e4a and node1:e8a.
Answer: A
NEW QUESTION 17
You completed an ONTAP cluster deployment as a reseller engineer. During the knowledge transfer process to the customer, they ask for proof that the array has correct multi-path HA cabling deployed and that the array is error free.
Which documentation output would you present to the customer to satisfy this requirement?
- A. Active IQ OneCollect output
- B. Config Advisor output
- C. NetAppDocs output
- D. Active IQ Unified Manager output
Answer: B
NEW QUESTION 18
Click the Exhibit button.
You are setting up a new AFF A700 into a new rack at a customer's site. The customer asks you to plan for simplified future growth.
Referring to the exhibit, how would you satisfy this requirement?
- A. Option 1
- B. Option 2
- C. Option 4
- D. Option 3
Answer: B
NEW QUESTION 19
What should you do to change the data protocol of a LIF?
- A. Delete and re-recreate the LIF.
- B. Put the LIF in another broadcast domain.
- C. Add the new data protocol to the LIF.
- D. Shut down the assigned port.
Answer: A
NEW QUESTION 20
Click the Exhibit button.
Referring to the exhibit, what information is forwarded to syslog after you enter the scripted install commands? (Choose two.)
- A. command history
- B. AutoSupport messages
- C. SNMP traps
- D. EMS messages
Answer: A,B
NEW QUESTION 21
You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are unable to discover the ONTAP controllers.
Which statement explains this behavior?
- A. You do not have network discovery enabled.
- B. You do not have a default gateway set.
- C. You do not have a static IP address.
- D. You do not have IPv6 configuration set.
Answer: B
NEW QUESTION 22
In an ONTAP switched cluster, which three types of traffic travels over the cluster network? (Choose three.)
- A. Epsilon voting
- B. intracluster SnapMirror
- C. cluster database replication
- D. remote cluster peering
- E. intercluster SnapMirror
Answer: C,D,E
NEW QUESTION 23
You are setting up a new AFF A400 that will serve iSCSI LUNs. You will have four iSCSI SVMs that each need to connect to an Internet Storage Name Service (iSNS) for discovery and management purposes.
In this scenario, which network interface is needed for each SVM to register with the name service?
- A. intercluster LIF
- B. SVM management LIF
- C. node management LIF
- D. SVM data LIF
Answer: A
NEW QUESTION 24
You installed a new pair of Cisco 92300YC cluster switches at a customer's site. Before you install any files on the switch, you want to view the current configuration.
In this scenario, which command would you use to accomplish this task?
- A. fabricshow
- B. show running-config
- C. switchcfgshow
- D. config show
Answer: C
NEW QUESTION 25
You have an AFF All SAN Array (ASA) cluster that is running ONTAP 9.7. The cluster is configured for Active Directory domain controller access using a domain tunnel.
In this scenario, which two licenses are enabled on the cluster? (Choose two.)
- A. NVMe
- B. iSCSI
- C. CIFS
- D. FCP
Answer: C,D
NEW QUESTION 26
You install a 4-node cluster with an AFF A400 HA pair and a FAS8300 HA pair. After setup, you are asked to review the audit logs on each controller from a Web browser.
In this scenario, which method provides access to the logs from a Web browser?
- A. ACP
- B. ADP
- C. SPI
- D. DNS
Answer: C
NEW QUESTION 27
You are installing a new AFF A400 cluster that is running ONTAP 9.7 software. You are asked to attach an Amazon S3 cloud tier for FabricPool technology.
In this scenario, which two NetApp License File (NLF) types are supported for cloud tiering? (Choose two.)
- A. master
- B. term-based
- C. perpetual
- D. base
Answer: B,C
NEW QUESTION 28
You are installing a new AFF A400 cluster and need to access the cluster management LIF from a remote subnet with the fully qualified domain name (FQDN) a400.lab.netapp.com.
In this scenario, which two network components must be configured to log in to ONTAP System Manager from the remote subnet? (Choose two.)
- A. route
- B. NTP
- C. DNS
- D. VLAN
Answer: A,C
NEW QUESTION 29
......
Verified NS0-184 dumps Q&As - 100% Pass from TestValid: https://lead2pass.testvalid.com/NS0-184-valid-exam-test.html