[2023] 300-515 PDF Questions - Perfect Prospect To Go With TestValid Practice Exam
Cisco 300-515 Pdf Questions - Outstanding Practice To your Exam
Cisco 300-515 exam is an industry-leading certification that validates a candidate's skills and knowledge in implementing Cisco Service Provider VPN Services. Passing 300-515 exam can enhance an IT professional's career prospects and open up new opportunities in the service provider industry. Candidates can prepare for the exam by taking training courses, studying the official exam guide, and practicing with sample questions and simulations.
NEW QUESTION # 13
Refer to the exhibit.
An engineer is implementing an MPLS P2MP TE solution. Which type of router can serve as the midpoint router and the tailend router in this P2MP TE network implementation?
- A. headend
- B. bud
- C. transit
- D. source
Answer: B
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/routers/asr920/configuration/guide/mpls/mp-te-path-setup- xe-3s-asr920-book/mp-te-path-setup-xe-3s-asr920-book_chapter_01.html
NEW QUESTION # 14
While troubleshooting an AToM L2VPN service, a network consultant notices that the AC Layer 2 encapsulations are different. Which action should the consultant take in order to make the MPLS L2VPN work?
- A. nonrouted interworking setup to properly translate only the Layer 2 information from the AC
- B. tag-rewrite on the ingress and egress PE router
- C. interworking IP configuration on both the AC terminations on the PEs
- D. interworking IP configuration on the last PE router before label disposition
Answer: C
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_l2_vpns/configuration/xe-16-11/mp-l2-vpns- xe-16-11-book/l2vpn-interworking.html
NEW QUESTION # 15
An engineer is troubleshooting an EoMPLS circuit on a Cisco IOS XR router interface that removes a VLAN from the distribution layer. Which configuration should the engineer apply in order to accomplish the task?
- A. interface GigabitEthernet 0/10.l2transport
encapsulation dot1q 10
rewrite ingress tag pop 1 symmetric
l2vpn
xconnect group 103588
p2p 103588
interface GigabitEthernet 0/10.10
neighbor ipv4 10.10.10.2 pw-id 103588 - B. interface GigabitEthernet 0/10.10
encapsulation dot1q 10
rewrite ingress tag pop 1 symmetric
l2vpn
xconnect group 103588
p2p 103588
interface GigabitEthernet 0/10.10
neighbor ipv4 10.10.10.2 pw-id 103588 - C. interface GigabitEthernet 0/10.10 l2transport
encapsulation dot1q 10
l2vpn
xconnect group 103588
p2p 103588
interface GigabitEthernet 2/10.10
neighbor ipv4 10.10.10.2 pw-id 103588 - D. interface GigabitEthernet 0/10.10 l2transport
encapsulation dot1q 10
rewrite ingress tag translate 1-to-1 dot1ad 10
symmetric
l2vpn
xconnect group 103588
p2p 103588
interface GigabitEthernet 0/10.10
neighbor ipv4 10.10.10.2 pw-id 103588
Answer: C
Explanation:
Section: Layer 2 VPNs
NEW QUESTION # 16
DRAG DROP
Drag and drop the EVPN components from the left onto the correct planes on the right.
Select and Place:
Answer:
Explanation:
Section: Layer 2 VPNs
Explanation/Reference: https://www.cisco.com/c/dam/m/en_us/network-intelligence/service-provider/digital- transformation/knowledge-network-webinars/pdfs/0420-epn-ckn.pdf slide 8
NEW QUESTION # 17
Refer to the exhibit.
Which statement about this command is true?
- A. It is used to set the router that will server as the root bridge for STP.
- B. It must be configured on the PE and CE router to enable MP-BGP to send labels for CSC.
- C. It must be configured on each PE router to enable the PE routers to receive multicast traffic for this particular MVRF.
- D. It is used to set the designated router on a link using PIM-SM.
Answer: C
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/routers/asr1000/configuration/guide/chassis/asrswcfg/ lsmmldp.html
NEW QUESTION # 18
An engineer is troubleshooting an ongoing network outage. Which command should he use that can display the live log files for a process or service running on a network device?
- A. show run
- B. ping
- C. debug
- D. traceroute
Answer: C
NEW QUESTION # 19
Refer to the exhibit. Which statement describes the result of this BGP configuration?
- A. R1 operates using IPv4 and VPNv4 address families.
- B. R1 establishes a VPNv4 eBGP relationship with neighbor 192.168.1.1.
- C. R1 establishes an iBGP relationship with peer 192.168.1.1.
- D. R1 operates on IPv6 only because the bgp default ipv4-unicast command is missing.
Answer: C
NEW QUESTION # 20
Which condition must be met before an environment can support CSC?
- A. The CSC-PE and the CSC-CE must support IPv6.
- B. The CSC-CE must support OSPFv3.
- C. The CSC-PE and CSC-CE devices must be able to send labels to one another using BGP.
- D. The CSC-PE and CSC-CE must each be able to ping an interface in its respective global routing table.
Answer: C
NEW QUESTION # 21
Refer to the exhibit. Which result occurs when PE1 learns a new MAC address and all three PEs are enabled with EVPN native?
- A. The MAC address is entered into the CAM table and is classified for use on the native VLAN
- B. The new MAC address is sent by BGP to PE2 and PE3 as a Type 2 BGP route.
- C. The MAC address is entered into the CAM table only if it is learned on the native VLAN.
- D. A system notification is sent to the network administrator that triggers the manual configuration of the new MAC address on PE2 and PE3.
Answer: B
NEW QUESTION # 22
Refer to the exhibit.
Drag and drop the EVC configuration items from the left onto the correct descriptions on the right.
Answer:
Explanation:
NEW QUESTION # 23
Which mechanism reduces the network flooding caused by host ARP learning behavior?
- A. BPDU guard
- B. ARP suppression
- C. root guard
- D. storm control
Answer: B
NEW QUESTION # 24
Refer to the exhibit.
If the two devices are operating normally, which two conclusions can you draw from this configuration? (Choose two.)
- A. CE1 is supporting CSC.
- B. The PE-CE routes between the devices are being exchanged by OSPF
- C. PE1 labels the routes it learns from CE1 with the route-target 111:1 and shares them with its VPNv4 peers.
- D. PE1 labels the routes it learns from CE1 with the route-target 222:2 and shares them with its VPNv4 peers.
- E. CE1 must use OSPF to establish a neighbor relationship with PE1.
Answer: B,E
NEW QUESTION # 25
With Layer 3 MPLS VPN implementations on Cisco IOS XR PE routers, an interface is assigned to a VRF using the vrf command in which configuration mode?
- A. RP/0/RP0/CPU0:PE(config-bgp)#
- B. RP/0/RP0/CPU0:PE(config-vrf)#
- C. RP/0/RP0/CPU0:PE(config-bgp-af)#
- D. RP/0/RP0/CPU0:PE(config-if)#
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios_xr_sw/iosxr_r3-7/mpls/configuration/guide/gc37v3.html
NEW QUESTION # 26
Refer to the exhibit.
Which statement about this command is true?
- A. It is used to set the router that will server as the root bridge for STP.
- B. It must be configured on the PE and CE router to enable MP-BGP to send labels for CSC.
- C. It must be configured on each PE router to enable the PE routers to receive multicast traffic for this particular MVRF.
- D. It is used to set the designated router on a link using PIM-SM.
Answer: C
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/routers/asr1000/configuration/guide/chassis/asrswcfg/ lsmmldp.html
NEW QUESTION # 27
Which two are characteristics of using a non-MPLS peer-to-peer model over a traditional overlay model? (Choose two.)
- A. The configuration on a newly added site PE is updated automatically.
- B. The model is suited for nonredundant configurations.
- C. Routing information is exchanged between the customer router and one or a few PEs.
- D. The customer specifies the exact site-to-site traffic profile.
- E. Provider routers know the customer network topology.
Answer: C,E
NEW QUESTION # 28
Refer to the exhibit.
A network operator is implementing EVPN IRB on PE1. Which two command placements enable the advertisement of Type 2 routes and what information do Type 2 routes contain? (Choose two.)
- A. Type 2 routes contain MAC/IP information.
- B. The operator adds in "host-routing" under the VRF EVPN.
- C. Type 2 routes contain Ethernet Auto-Discovery information.
- D. Type 2 routes contain inclusive source-specific multicast route information.
- E. The operator adds in "host-routing" under the BVI651 interface.
Answer: A,E
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/iosxr/ncs5500/vpn/61x/b-ncs5500-l2vpn-configuration- guide-61x/b-ncs5500-l2vpn-configuration-guide-61x_chapter_01010.html
NEW QUESTION # 29
Refer to the exhibit.
Which statement about this command is true?
- A. It is used to set the router that will server as the root bridge for STP.
- B. It must be configured on the PE and CE router to enable MP-BGP to send labels for CSC.
- C. It must be configured on each PE router to enable the PE routers to receive multicast traffic for this particular MVRF.
- D. It is used to set the designated router on a link using PIM-SM.
Answer: C
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/asr1000/configuration/guide/chassis/asrswcfg/lsmmldp.html
NEW QUESTION # 30
......
Cisco 300-515 exam covers a range of topics, including implementing various VPN technologies such as IPsec, SSL, and MPLS Layer 3 VPNs, configuring VPN services on Cisco routers and switches, and troubleshooting common issues related to VPN connectivity. Passing 300-515 exam demonstrates an individual's ability to design, configure, and manage secure VPN services and ensures that they are equipped with the skills necessary to meet the evolving demands of the IT industry.
Online Questions - Outstanding Practice To your 300-515 Exam: https://lead2pass.testvalid.com/300-515-valid-exam-test.html